







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Bathroom Remodeling: The Sunrise Manor Owner’s Guide
Schluter bathroom remodeling in Sunrise Manor typically runs $9,000 to $28,000 for a full bathroom, with Schluter waterproofing systems (Kerdi, Ditra, Kerdi-Board) built into the assembly rather than added later. Smaller projects, such as a shower-only rebuild or a tub-to-shower conversion with Schluter membrane, land between $3,000 and $12,000. We can usually inspect a failing Schluter installation within a few days of your call, and written estimates are free.
Sunrise Manor homeowners most often discover a Schluter problem the same way: a hairline crack along the shower curb, a soft spot in the floor tile near the drain, or grout that keeps darkening no matter how often it’s cleaned. Sometimes it’s a loose tile that flexes underfoot, or a musty smell that returns within weeks of a deep clean. These are rarely grout problems. They are almost always signs the waterproofing layer underneath has been compromised, or was installed incorrectly the first time. Las Vegas Valley’s hard water and the extreme swing between summer heat and winter cool make those failures show up faster here than in milder climates.
Which Schluter Models This Applies To

Schluter’s bathroom systems fall into a few families, and knowing which one you have changes both the repair approach and the parts involved.
- Kerdi and Kerdi-Band: the thin sheet-applied waterproofing membrane used behind tile in showers and wet areas. Comes in 5-inch and 7-inch band widths; the 5-inch is standard for seams, the wider roll for corners and floor-to-wall transitions.
- Kerdi-Board: cement-free foam building panels in 1/2-inch and 3/8-inch thicknesses, used as tile backer in showers. Common failure: board seams that weren’t banded, or fasteners driven through the waterproof face.
- Ditra and Ditra-XL: the uncoupling membrane under floor tile. The orange mat separates the tile from substrate movement. Ditra is 1/8-inch; Ditra-XL is 5/16-inch and used on larger-format tile.
- Kerdi-Line and Kerdi-Drain: linear and point drains with integrated bonding flanges. Kerdi-Line comes in multiple lengths and grate finishes; replacing a grate alone is possible, replacing the drain body is a tear-out.
- Kerdi-Fix and Kerdi-Seal: sealant and sealing tape for penetrations and transitions to other materials.
Identifying what you have: pull a loose tile edge or look inside the shower valve trim. Kerdi membrane is a fleece-faced orange or gray sheet. Kerdi-Board is a lightweight foam core with a cementitious coating. Ditra is unmistakable – the dovetail orange mat. Write down any part number stamped on the edge; it tells us the roll width and whether it’s the current spec or an older version.
OEM vs. aftermarket: for Schluter specifically, we recommend genuine Schluter components for anything in the waterproofing layer. The fleece on Kerdi and the dovetail geometry on Ditra are engineered as a system, and generic “uncoupling mats” or “waterproofing sheets” don’t carry the same bonding specs or the same warranty backing. For finish items like drain grates or trim profiles, high-quality aftermarket equivalents are fine. Mason Remodeling Sunrise Manor is an independent service provider and is not affiliated with Schluter; we specify genuine Schluter parts because they’re what the system was tested with, not because we’re obligated to.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Bathroom Remodeling Is Failing
These are the symptoms we see most often when we inspect a bathroom in Sunrise Manor that has a Schluter installation behind the tile:
- Efflorescence or white crust along the curb or floor line. Moisture is moving through the tile assembly and depositing salts on the surface. Underlying cause: a break in the Kerdi membrane at a seam, corner, or fastener penetration.
- Grout that darkens and stays dark after cleaning. The grout is wicking water from behind, not from the surface. Cause: missing Kerdi-Band at a wall-to-floor transition, or thinset applied too thin to bond the fleece.
- Hollow-sounding tile when tapped. The tile has debonded from the substrate. Cause: Ditra installed over a floor that wasn’t flat enough, or the mat’s fleece never fully engaged the thinset.
- A musty odor that returns within weeks. Water is trapped in the assembly and colonizing the backer or framing. Cause: shower pan that doesn’t drain to the weep holes, often from a Kerdi-Drain that was set too high.
- A hairline crack along the shower curb or floor joint. Movement between two planes. Cause: no Kerdi-Band bridging the joint, or the band was embedded with the wrong mortar.
Las Vegas Valley water runs hard (typically 250 to 300 mg/L calcium carbonate), which accelerates scale buildup on grout and drain grates and makes a pinhole leak in the waterproofing show up much faster than on the coast. If you’re seeing any of these signs, the earlier we look the smaller the repair.
Replacement Cost & What’s Included

What a repair or remodel actually costs in Sunrise Manor depends on whether the waterproofing layer is intact and whether tile has to come out. Here are the ranges we quote:
| Project | Installed Range |
|---|---|
| Full bathroom remodel with Schluter Kerdi waterproofing | $9,000 – $28,000 |
| Small bathroom remodel (Kerdi shower + floor) | $5,000 – $12,000 |
| Walk-in shower installation (Kerdi-Board + Kerdi-Line) | $4,500 – $12,000 |
| Tub-to-shower conversion with Schluter pan and membrane | $3,500 – $10,000 |
| Shower replacement (tile, board, waterproofing only) | $3,000 – $8,500 |
| Bathroom vanity installation (Schluter-compatible floor and wall) | $800 – $3,000 |
What drives the range: whether the tile has to come off to reach the membrane, whether the drain body has to be replaced (a Kerdi-Drain swap is a bigger job than a Kerdi-Line grate swap), and the tile size and finish you choose. Our written price breaks out parts and labor separately, so you can see the actual Schluter components and what the install labor comes to. Every completed project is covered by the 365-Day Done Right Promise – if the work fails within 365 days of completion, we come back and make it right at no cost to you. Free second visit if a repair fails, no dispute process.
For surfaces, we work with Cambria, Silestone, and Caesarstone quartz, and for cabinetry we specify KraftMaid and Wellborn – all spec-grade manufacturers, all available through Mason Remodeling Sunrise Manor.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
There are a few things you can safely check yourself: confirm which Schluter product is on your wall or floor (peel back a loose tile edge or look through the valve trim), note the part numbers, and photograph the symptom. Run the shower for 5 minutes and watch for where water appears or grout darkens. Those observations will save us a diagnostic visit and let us quote faster.
What we advise against: trying to patch a Kerdi membrane or re-seam a corner yourself. The waterproofing layer is the reason the Schluter system works. A homeowner-applied patch of sealant over a seam, or “patching” with thinset, usually traps water in the wall cavity rather than stopping it. That turns a $400 repair into a $4,000 tear-out, and in a wet Las Vegas summer it can grow mold inside the wall within weeks. We’ve seen this go wrong repeatedly in Sunrise Manor, and it’s an expensive lesson.
The other honest limit: if the problem involves the drain body, the shower pan, or a Kerdi-Drain that was set too high, the fix involves removing tile and re-doing the pan. That’s not a homeowner project. Give us a call at (855) 606-6122 and we’ll tell you straight whether it’s a patch or a rebuild.
FAQs

A correctly installed Schluter waterproofing system typically lasts 25 to 30 years or more in a residential bathroom. The membrane itself doesn’t wear out; the failure points are the seams, the penetrations, and the drain. Properly banded seams and a correctly set Kerdi-Drain are what give you that lifespan. Sunrise Manor’s hard water means grout and drain grates need periodic cleaning, but the membrane underneath should outlast the tile. Call (855) 606-6122 for a free inspection if you’re seeing symptoms.
Sometimes. A localized Kerdi seam failure can often be repaired by removing the affected tile, re-banding the seam with genuine Kerdi-Band and Kerdi-Fix, and re-tiling that section. A compromised pan, a failed Kerdi-Drain set, or widespread unbonded Ditra under the floor usually requires a full tear-out. An on-site inspection tells you which one you’re dealing with; estimates are free.
A localized seam or drain repair typically takes one to two days. A shower rebuild or tub-to-shower conversion with fresh Schluter waterproofing usually runs two to three weeks, plus cure time before daily use. A full bathroom remodel in Sunrise Manor is typically three to five weeks depending on scope, fixture lead times, and tile. You’ll get a written timeline with the written price before work starts.
We specify genuine Schluter components – Kerdi-Band, Kerdi-Board, Ditra, Kerdi-Line, Kerdi-Drain, Kerdi-Fix – sourced through authorized distributors before the project begins. Because we don’t carry parts on a truck, we confirm the exact part number and roll or board size against your installation during the estimate, so there’s no mid-job substitution and no wait on a wrong part. Every crew member is identity-verified and background-checked through The Threshold Standard, and you’ll receive their name and photo before they arrive.
Get a Written Price on Your Schluter Bathroom Project
If your Sunrise Manor bathroom is showing signs of a failing Schluter installation – dark grout, a soft spot, a hollow tile, a musty smell – the next step is a free estimate. We’ll confirm which system you have, tell you honestly whether it’s a repair or a rebuild, and hand you a written price before any work starts. Every crew member who comes to your door is background-checked, identity-verified, and introduced by name and photo ahead of the visit, with a photo ID badge on arrival. Call (855) 606-6122 to schedule your free estimate – a live person answers 24 hours a day, every day of the year.
Written by the team at Mason Remodeling Sunrise Manor, serving Sunrise Manor and nearby areas.












