







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boral Home Additions & ADU: The Sunrise Manor Owner’s Guide
We build and finish Boral home additions and ADU projects across Sunrise Manor, and an installed addition typically runs $45,000 – $130,000 depending on footprint and finish level, with ADUs priced separately. When a Boral component fails, owners usually find it the hard way: a siding panel or trim board that has chalked, cupped or pulled loose after a summer of 110-degree afternoons, or a threshold that quit sealing after a monsoon push. This page exists for the Sunrise Manor homeowner holding a Boral product that is failing, or planning an addition and wondering which Boral line fits the desert. Here is how we match parts, what they cost, and when to call.
Which Boral Models This Applies To

Boral makes a lot of exterior building products, and “Boral” on a failed piece doesn’t tell us which one you have. Most Sunrise Manor homes we see run Boral siding, trim, or stone veneer on the addition exterior, and the match depends on the exact line. Look for a stamp, label, or ink mark on the back of the piece, usually near one end of a siding panel or on the back face of trim. If the label weathered off, measure the exposed face width and thickness and photograph the profile edge-on. That gets us close enough to identify the series.
For Boral specifically, OEM versus aftermarket is a real fork in the road. Third-party panels that “match” a Boral profile are often off by a sixteenth of an inch in thickness or a few degrees in the lock angle, which shows up as oil-canning or loose laps once the sun works on it. For an addition, we order the OEM piece or a manufacturer-approved equivalent whenever it is still in production. If a line has been discontinued, we’ll tell you straight and show you the closest current Boral profile instead of quietly substituting a generic panel. Your Sunrise Manor addition deserves a correct match, not a near-miss.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Boral Home Additions & ADU Is Failing
Here are the failure modes we actually see on Boral exterior work around Sunrise Manor, and what’s driving each one:
- Cupping or bowing panels. The panel is absorbing moisture faster than it dries, usually because the piece was face-nailed tight instead of allowed to move, or the cut edge was never sealed. In our heat, unsealed edges swell first.
- Chalking and faded color. Surface chalk is normal wear, but heavy fading on a south or west-facing wall is UV breakdown of the finish coat. Once it chalks, the panel is accepting paint poorly and will need either refinishing or replacement.
- Loose laps and popped fasteners. Thermal cycling from day to night in the desert is brutal on anything fastened rigidly. The fastener heads back out and the lap opens, which is where water finds its way in.
- Caulk lines cracking at joints and corners. The caulk failed before the panel did. A joint that was caulked instead of flashed is the first place we look on a leak call.
- Soft or crumbling trim at the base and threshold. Water is pooling against the piece instead of shedding off it. On an addition, that usually means the flashing detail at the wall tie-in is wrong, not that the Boral trim was bad.
Replacement Cost & What’s Included

Repair and replacement on Boral exterior work depends on how much area is affected, access, and whether the underlying flashing has to be corrected. Here’s where installed pricing lands in Sunrise Manor for the broader addition and ADU work, so you can self-qualify before you call:
| Project | Installed Price Range |
|---|---|
| Home Addition (full project) | $45,000 – $130,000 |
| ADU Construction | $90,000 – $220,000 |
| Garage Conversion | $30,000 – $80,000 |
What drives the range on an addition is footprint, foundation work, whether the roofline ties into the existing house, and finish level. On a target repair like a failing Boral panel run, the driver is access and how much hidden flashing has to be replaced. We deliver a written price before any work starts, and that price separates the part from the labor so you can see what you’re paying for. Every project we finish is covered by our written guarantee, with terms stated plainly, and we apply the 365-Day Done Right Promise: if the work isn’t right within a year of completion, we make it right at no cost to you.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Some of this you can safely check yourself. Walk the wall, look for loose laps and popped fasteners, and photograph the back of any panel you can reach without a ladder. What we’d steer you away from is climbing a ladder to pull panels or re-flash a wall tie-in on your own. Water intrusion gets into a wall cavity and does its damage quietly, and a reused panel that feels tight can still be wrong on the flashing underneath. That’s not an honest DIY job.
When we come out, we’ll identify the Boral line, tell you whether the piece can be repaired or has to be replaced, and leave you with a written price before anything starts. Every crew member is background-checked and identity-verified under The Threshold Standard, and we send you the technician’s name and photo before the visit and show a photo ID badge at the door. Call (855) 606-6122 for a free estimate on your Sunrise Manor addition or repair.
FAQs

Boral siding and trim typically last 20 – 30 years with proper installation and care, but in Sunrise Manor’s UV and heat you should expect the finish coat to need attention sooner than the substrate fails. South and west-facing walls take the worst of it. We look at chalked and faded panels first when we assess a wall. Call (855) 606-6122 for an exact quote on repair or replacement, and estimates are free.
Yes, sometimes, if the panel is sound but the fastener, lap, or caulk joint failed. If the substrate has swollen or the flashing behind it is wrong, the panel has to come off for a real fix. We’ll tell you which you’re looking at before any work begins. Call (855) 606-6122 for a free estimate.
A single failing panel run or a trim repair usually finishes in a day or two, while a full addition that includes Boral exterior work runs weeks to months. Access, drying time for any wet substrate, and whether flashing has to be rebuilt set the schedule. You’ll get a written timeline with the written price. Call (855) 606-6122 to schedule your estimate.
We identify your Boral line from the panel label or measured profile, then order the OEM piece or a manufacturer-approved equivalent through trade supply channels, and we tell you if the line is discontinued before we substitute anything. We don’t carry parts on a truck or guarantee same-day availability. Call (855) 606-6122 to start the identification and get a written estimate.
We also work with KraftMaid, Cambria and Silestone on the interior side of additions and ADUs, so the finish work matches the structure. Mason Remodeling Sunrise Manor is an independent service provider and is not affiliated with Boral.
Get Your Free Estimate
Whether you’re holding a failed Boral piece or planning a Sunrise Manor addition or ADU from the ground up, we’ll walk the project with you, tell you exactly what needs to happen, and put the price in writing before any work starts. Our technicians have up to 22 years of experience, and a live person answers every call, day or night. Call Mason Remodeling Sunrise Manor at (855) 606-6122 to schedule your free estimate.
Written by the team at Mason Remodeling Sunrise Manor, serving Sunrise Manor and nearby areas.












