







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ActiveYards Home Additions & ADU: The Sunrise Manor Owner’s Guide
We build ActiveYards-compatible home additions and ADUs in Sunrise Manor, and installed projects here typically run $45,000 – $130,000 depending on size, foundation, and finish level. A detached ADU that adds a kitchen and full bath sits at the top of that range; a straightforward attached room addition sits near the bottom. Because additions are planned construction, not emergency work, the honest answer on timing is that we schedule a design visit first and give you a written price before anything gets ordered.
Owners usually call us after the problem shows itself in stages. The addition side of an ActiveYards build rarely fails all at once. You notice a hairline crack at the wall junction that gets wider each summer, a door that sticks in July and swings free by November, or a patio slab that has dropped a half inch against the house. On the ADU side, the tell is often a musty smell near a bathroom wall or a bedroom that never quite holds temperature. By the time someone searches for a part, the cause is usually movement or moisture working on the connection between the addition and the original house.
Which ActiveYards Models This Applies To

ActiveYards sells through a dealer network, and the exact part numbers behind a wall connection, threshold, or roof tie-in depend on which series and package your structure was built under. Because we’re an independent provider and not affiliated with ActiveYards, we identify the assembly from the building itself first, then confirm the part.
How to pin down compatibility:
- Find the labels before you measure. Engineered connector hardware (hangers, ties, anchor plates) is stamped with the manufacturer and a model code. A flashlight and a phone photo of that stamp saves a wrong order.
- Measure the actual opening, not the old part. Studs deflect and thresholds compress over time, so a 36-inch door opening may measure 35 3/4. Ordering off the removed part’s label gets you a repeat failure.
- Match the connector to the load path. A tie rated for a roof-to-wall connection and one rated for a floor-to-deck connection can look nearly identical. Swapping them is the most common mistake we see on an ActiveYards structure in Sunrise Manor.
- OEM vs aftermarket. For structural connectors, an OEM-spec or equal-rated part from a recognized manufacturer is what matters. For trim, flashing, and finish pieces, a quality aftermarket equivalent is often the smarter spend, and we’ll say so plainly rather than upsell.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ActiveYards Home Additions & ADU Is Failing
These are the five symptoms that bring Sunrise Manor homeowners to this page. Each one points to a specific cause, and knowing which you have changes the repair.
- A widening crack where the addition meets the original wall. This comes from differential movement: the addition footing settles slightly differently than the house footing, and the two structures move apart. Hairline is normal; a crack you can slide a nickel into is not, and it usually means a missing or failed expansion joint or a footing that needs investigation.
- Sticking doors and windows across seasons. Wood framing swells in the monsoon humidity and shrinks in the dry heat, so a door that binds in August and frees up in winter is telling you moisture is reaching the frame. It’s often a flashing or sealant failure at the threshold or header, not the door itself.
- Water staining on the ceiling near the roof tie-in. This points to a failed step flashing or a lifted counter-flashing where the addition roof meets the main roof. Sunrise Manor wind-driven rain finds these gaps fast, and the stain is usually weeks behind the actual leak.
- A settled or uneven floor at the connection threshold. Slab edges at the transition settle or heave, and the result is a slab crack or a threshold that no longer sits flush. Left alone, it damages both the door and the trim, and it’s the crack an owner sees before anything else.
- Musty odor or a cold spot in an ADU bathroom wall. A seal or vapor barrier at the wet wall has likely failed, letting moisture into the framing cavity. This is the one symptom we urge owners not to wait on, because interior framing rot spreads quietly and the repair grows with it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Honest installed ranges for the work behind an ActiveYards addition or ADU repair in Sunrise Manor:
| Scope | Installed Price Range |
|---|---|
| Home addition (repair or completion) | $45,000 – $130,000 |
| ADU construction | $90,000 – $220,000 |
| Garage conversion | $30,000 – $80,000 |
What drives the number: foundation work, whether the connection to the main house needs re-flashing or a new expansion joint, permit and inspection costs, and finish level. You get a written price before any work starts, not a verbal estimate, and the price holds unless you change the scope. Our technicians have up to 22 years of experience, and every project carries the 365-Day Done Right Promise: if the work isn’t right within 365 days of the completion date, we make it right at no cost to you.
DIY or Call Us?
Some checks are safe for an owner. You can photograph the connector labels, measure the opening with a tape, look for daylight or staining at the roof tie-in, and note whether a crack is stable or widening. That information helps us quote accurately, and we welcome it.
Where DIY goes wrong on an addition or ADU is structural and moisture work. Re-flashing a roof tie-in, resetting a settled threshold, or opening a wet wall to replace a failed vapor barrier all involve the load path and the building envelope. Get one of those wrong and you don’t find out for a season or two, when the water damage shows up. This isn’t a part you should swap yourself. That’s work for a trained crew, and it’s where we’d rather see you call us than take the risk.
Call (855) 606-6122 for a free estimate. We’ll confirm the right part for your ActiveYards structure, explain what’s included in the written price, and schedule the visit around you.
FAQs

A properly installed and flashed assembly should hold for decades, but the connectors and seals around it have a much shorter service life. In Sunrise Manor’s dry heat and monsoon swings, expect to inspect flashing, sealant, and expansion joints every few years, because they age faster than the framing and are the first thing to fail.
Often yes, and we’ll tell you when a repair is the right call rather than a full replacement. A failing sealant joint or step flashing is usually a targeted repair. A connector that’s under-rated for the load, or framing that’s already rotting behind the wall, needs replacement, and we’ll show you why before we start.
A focused repair like re-flashing or a threshold reset can be a few days; structural or envelope work on a larger addition runs longer and depends on permits and inspection timing. We give you the timeline in writing with the price so you’re never guessing.
We identify the correct part from your structure’s labels and measurements rather than guessing, then source an OEM-spec or equal-rated component from a recognized manufacturer. For finish pieces, we’ll recommend a quality aftermarket equivalent when it’s the better value. We don’t stock parts on a truck, so the part is ordered for your job specifically.
We also service KraftMaid, Cambria, and Silestone projects. Call (855) 606-6122 to schedule your free estimate in Sunrise Manor and get the right part matched to your ActiveYards structure.
Written by the team at Mason Remodeling Sunrise Manor, serving Sunrise Manor and nearby areas.












