







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Quikrete Driveway & Pavers: The Sunrise Manor Owner’s Guide
We install Quikrete driveway and paver systems across Sunrise Manor, and most full installations run $7,000-$18,000 for pavers or $4,500-$12,000 for a poured concrete driveway, depending on square footage, base prep, and how much old surface has to come out. Small repairs and resealing sit far lower. We quote every job in writing before work starts, and estimates are free.
Homeowners here usually spot trouble the same way. A hairline crack opens across a Sunrise Manor driveway after a summer of 115°F afternoons. A paver edge sinks and one corner of the walk starts rocking underfoot. Or the joint sand washes out during a monsoon gully-washer and weeds push up between the stones by the following spring. Quikrete makes the concrete mixes, paver joint sand, and setting materials behind a big share of the hardscape in this valley, so when one of those products fails, it’s rarely the bag’s fault. It’s almost always the base underneath it, the water management around it, or how the mix was placed in desert heat.
Key Takeaways
- Typical installed range in Sunrise Manor: $4,500-$18,000 depending on material and size.
- Most Quikrete hardscape failures we see trace back to base prep and drainage, not the product.
- Quikrete is a material brand, not an equipment model, so “matching the part” means matching the mix, joint sand, and sealer to the surface type and our climate.
- We’re an independent service provider. We’re not affiliated with Quikrete.
Which Quikrete Models This Applies To

Quikrete doesn’t build driveways or pavers as a machine with a serial number. It sells the materials that hold a driveway together, and that’s the first thing to understand when you’re trying to “match a part.” The right product depends on the surface, not a model line.
For poured concrete driveways, the relevant Quikrete products are the high-strength concrete mixes (the 4000 PSI and 5000 PSI bags are the common picks) and the bonding and patching products used for repairs. For paver installations, it’s the paver base material, the polymeric joint sand, and the concrete setting bed if the design calls for one. For sealing existing concrete or pavers, it’s the concrete sealer and paver sealer lines.
How to identify what you actually need: check the label on any leftover bags in the garage, then measure the failing area and note the surface type, the depth of any settled section, and whether water pools there after rain. That last detail matters more than the brand on the bag. In Sunrise Manor, our caliche-heavy soil and thin monsoon runoff mean the base layer and slope carry the load, and a premium mix over a bad base still cracks.
On OEM versus aftermarket: Quikrete is itself the mainstream brand, so there’s no exotic “factory part” to chase. What matters is matching compressive strength, joint sand type, and sealer chemistry to the surface. A cheap generic patch compound over a 5000 PSI slab is a false economy; the repair fails within a season. We source specification-grade materials for the job rather than whatever’s closest on the shelf.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Quikrete Driveway & Pavers Is Failing
These are the symptoms Sunrise Manor homeowners describe when they call us, and what’s usually behind each one:
- Hairline cracks spreading across a concrete driveway. Caused by shrinkage during curing combined with our extreme day-night temperature swings. Small cracks let monsoon water in, and one hard freeze-free winter of expansion is enough to widen them into structural splits.
- Pavers that rock or sink at the edges. The base beneath them has settled or wasn’t compacted deep enough. This is the single most common Quikrete paver failure we see, and it almost always shows up at the driveway apron and along the garage approach first.
- Joint sand washing out after a storm. Polymeric joint sand that wasn’t properly activated, or was installed in the wrong temperature window, never locks. Once it loosens, water channels between pavers and weeds move in.
- Efflorescence, the white chalky bloom on concrete or pavers. Moisture is moving through the slab and pulling salts to the surface. It can be a cosmetic nuisance, but recurring bloom often signals a drainage problem underneath.
- Ponding water that sits for hours after rain. A slope or grading issue that no amount of patching fixes. Left alone, standing water works its way into every joint and accelerates everything else on this list.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what the work typically runs in Sunrise Manor, priced as installed projects rather than bag costs:
| Service | Installed Price Range |
|---|---|
| Paver driveway installation | $7,000-$18,000 |
| Concrete driveway installation | $4,500-$12,000 |
| Asphalt driveway paving | $3,500-$9,000 |
| Driveway replacement | $5,000-$14,000 |
| Driveway sealing | $250-$700 |
| Paver patio installation | $3,500-$11,000 |
What moves you up or down that range: square footage, how much demolition and haul-away the old surface needs, base depth and compaction, and whether drainage correction is part of the scope. We separate material cost from labor on the written quote so you can see exactly where the money goes. Every installation is covered by our written guarantee, and we’ll spell out what’s covered and for how long before you commit.
DIY or Call Us?
Some of this is genuinely fine to handle yourself. Replacing washed-out joint sand on a small paver walk, applying a fresh coat of sealer to a sound concrete driveway, and cleaning efflorescence with the right product are all reasonable weekend jobs if you follow the label.
Where DIY goes sideways is base and structure. You can’t fix a settled paver base by topping it with sand, and patching cracks without addressing the water source underneath just buys you one more season. Getting a driveway base right means excavation, proper compaction in lifts, correct slope for runoff, and placing concrete in conditions that won’t cause it to cure too fast in desert heat. That’s a crew and equipment job, not a wheelbarrow job.
If you’re not sure which side of the line your project falls on, call us at (855) 606-6122 and describe what you’re seeing. A live person answers around the clock, and we’ll tell you honestly whether it’s a repair or a replacement.
Frequently Asked Questions

A properly installed concrete driveway typically lasts 25 to 30 years, and a paver driveway can last 30 or more with periodic joint sand refresh and resealing. In Sunrise Manor’s climate the sun and temperature swings are the biggest factors: UV degrades sealers faster here than in cooler regions, so we recommend resealing concrete every 3 to 5 years and refreshing polymeric joint sand on pavers as it wears. Call (855) 606-6122 for a free assessment of your current driveway.
Often yes. Isolated cracks, settled pavers, and worn joint sand can be repaired rather than replaced, and that’s usually the smarter spend. Full replacement makes sense when cracking is structural across the slab, when settlement is widespread, or when drainage is failing underneath. We’ll give you an honest read on which category your driveway falls into before quoting anything.
Sealing takes a day, small repairs typically one to two days, and a full driveway replacement usually runs three to seven days depending on size, material, and cure time. Our technicians have up to 22 years of experience with hardscape and know how to sequence the work around desert heat so the material cures correctly. Call (855) 606-6122 to schedule a free estimate.
We spec the material to the surface and the site, not to a generic list. That means matching compressive strength for concrete, the correct joint sand type for pavers, and a sealer rated for our UV load, then sourcing it from our specification-grade supplier relationships. Before work starts, you get a written price with the material and labor broken out, and a technician’s name and photo before the visit. We’re an independent provider and not affiliated with Quikrete. For hardscape and interior projects alike, we also work with KraftMaid, Cambria, and Silestone materials.
Whether you’re weighing a patch or a full replacement, the next step is a free, no-pressure estimate. Call (855) 606-6122 and we’ll walk your driveway, give you a written price before any work begins, and back the finished job with our 365-Day Done Right Promise. Our crews are background-checked, arrival-verified, and we answer the phone 24 hours a day.
Written by the team at Mason Remodeling Sunrise Manor, serving Sunrise Manor and nearby areas.












