







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Bathroom Remodeling: The Sunrise Manor Owner’s Guide
We remodel bathrooms in Sunrise Manor that incorporate Tamko products, and most full bathroom remodels here run $9,000 to $28,000 installed, with smaller projects landing in the $5,000 to $12,000 range. If you’re reading this, you’ve likely found the problem the hard way: a loose tile edge, a soft spot near the shower pan, or a grout line that keeps reopening no matter how many times you seal it. Tamko is best known for roofing and waterproofing membranes, and when those materials go into a bathroom, the failure usually shows up at the wet edges first – the curb, the wall seam, the floor transition.
We’re an independent remodeling company, not affiliated with Tamko. We work with the materials and we know where they tend to wear out in Southern Nevada’s dry heat and hard water.
Key Takeaways
- Full bathroom remodels in Sunrise Manor: $9,000 – $28,000; small baths: $5,000 – $12,000.
- Tamko waterproofing membranes are the most common failure point we see in bathrooms that were built or patched in the last decade.
- Most failures show up at the shower curb, the wall-to-floor seam, and around the drain flange.
- A written price is delivered before any work starts, and every project carries our 365-Day Done Right Promise.
- Our technicians have up to 22 years of experience with waterproofing and tile work.
Which Tamko Models This Applies To

Tamko makes several waterproofing and underlayment products that end up in bathrooms, and identifying the right one starts with the label. Peel-and-stick membranes, liquid-applied waterproofers, and sheet membranes each have a different installation method, and mixing up the spec is where problems start. If the original packaging is gone, the membrane thickness and backing paper texture are your best clues – a peel-and-stick roll will have a release liner, while a liquid-applied product leaves a painted-on film.
The compatibility gotcha: some Tamko membranes are rated for use under thinset mortar and some are not. Using the wrong adhesive over a membrane that wasn’t designed for it causes bond failure within months, and in Sunrise Manor’s heat, that failure happens faster than the product data sheet suggests. Check the membrane’s printed rating before you buy thinset, and match the modified or unmodified mortar to what the label actually says.
On the OEM-versus-aftermarket question: for membranes and flashing, the OEM product is worth the small price difference because the warranties and installation specs are tied to the brand. For tile, grout, and fixtures, aftermarket equivalents are often just as good. We’ll tell you which is which before you spend a dollar.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Bathroom Remodeling Is Failing
- Grout lines that reopen after sealing. This usually means moisture is getting behind the tile, not evaporating from the surface. A membrane failure at the wall seam is the common cause.
- A soft or spongy spot near the shower curb. Water has reached the substrate. In Sunrise Manor, we see this most in showers built with a flat curb and no pre-slope under the membrane.
- Loose tiles at the floor-to-wall transition. The membrane has likely debonded at the edge where movement is greatest. This is the first place we probe on any inspection.
- Musty smell that returns after cleaning. Trapped moisture under the tile or behind the wall. It doesn’t clear up with a new coat of paint or a deeper clean.
- Staining or bubbling on the ceiling below. Water has traveled through the subfloor or wall cavity. This one needs attention before anything else on this list.
Each of these symptoms points to a different layer of the assembly. A membrane that failed at the curb is a different repair than one that failed at the drain flange, and the price reflects that difference. We check all five before quoting so the number you get is the number you pay.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
| Project | Installed Range (Sunrise Manor) |
|---|---|
| Full bathroom remodel | $9,000 – $28,000 |
| Small bathroom remodel | $5,000 – $12,000 |
| Walk-in shower installation | $4,500 – $12,000 |
| Tub-to-shower conversion | $3,500 – $10,000 |
| Shower replacement | $3,000 – $8,500 |
| Bathroom vanity installation | $800 – $3,000 |
What drives the range: the condition of the substrate under the failed membrane, whether the drain and plumbing need to move, and the tile and fixture selections. A membrane failure that stayed contained is a repair; one that soaked the subfloor is a rebuild. Every quote is line-item and written before work begins – demolition, membrane, tile, fixtures, and labor each on their own line. The 365-Day Done Right Promise covers the installation for a full year from completion, and if anything we installed fails in that window, we come back and make it right at no cost.
DIY or Call Us?
You can safely check a few things without opening a wall: look for loose tiles, press on the curb to feel for softness, and check the ceiling below for staining. Those checks cost nothing and tell you whether the problem is surface-level or deeper.
Where DIY goes wrong is the membrane itself. Tearing out a shower to redo the waterproofing means removing tile, cutting back to the studs and subfloor, re-sloping the pan, and reinstalling the membrane to spec – one skipped step and you’re back to a leaking shower in a year. There’s no shortcut that holds up, and the redo costs more than the original job. We’d rather you call and get an honest answer than tear out a shower on a guess. Call (855) 606-6122 for a free estimate and we’ll tell you whether it’s a patch or a rebuild.
FAQs

A properly installed membrane should last 15 to 25 years. In Sunrise Manor’s heat and hard water, we see failures closer to the 10-year mark when the pre-slope was skipped or the wrong thinset was used. Call (855) 606-6122 for an exact quote on replacement – estimates are free.
Sometimes, yes. A contained failure at a single seam can be patched if the surrounding membrane is still sound. Once water has reached the substrate, a partial repair usually fails again within a year, and a full replacement is the better spend.
A small bath typically takes one to two weeks; a full remodel runs two to four weeks depending on tile and fixture lead times. We give you a schedule with the written price so you know what to expect.
We source through vetted professional supply channels and confirm the exact spec against your existing installation before ordering. We also work with KraftMaid cabinetry, Cambria and Silestone surfaces, and Kohler and Moen fixtures when a remodel calls for them.
The 365-Day Done Right Promise covers our workmanship for 365 days from the completion date, with terms stated in writing. If a repair or installation fails, we return at no charge.
We verify every crew member by name and photo before they reach your door, and a live person answers the phone around the clock. When you’re ready, call (855) 606-6122 for a free estimate and a written price before any work begins.
Written by the team at Mason Remodeling Sunrise Manor, serving Sunrise Manor and nearby areas.












