







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Home Additions & ADU: The Sunrise Manor Owner’s Guide
We build Wellborn-cabinetry home additions and ADUs in Sunrise Manor, and installed prices here run $45,000 – $130,000 for an addition and $90,000 – $220,000 for a full ADU. Every project starts with a written price before any work begins, and our technicians have up to 22 years of experience. Homeowners usually discover a failing part the same way: a cabinet door in a new addition that no longer closes flush, a drawer that drags once summer humidity hits, or a hinge screw that spins loose after a season of Las Vegas Valley temperature swings pulling the box out of square.
This page is for the Sunrise Manor owner who has a Wellborn installation and a part that is not behaving. We match the part to your actual model, price it honestly in writing, and stand behind the install for 365 days from the completion date.
Which Wellborn Models This Applies To

Wellborn Cabinet builds across several lines – the cabinet you have matters for parts. The Woodlands series carries standard 32mm-system hinge boring, while the Select and Premier lines can shift on drawer glide mounting patterns and door overlay depending on when the box was made. Sunrise Manor homes finished in different years can sit on opposite sides of a running change.
Here is how to identify what you have before you call:
- Series label: Look inside the cabinet box, usually on the inside face of a side panel or the back of the sink base door. Wellborn prints the series and finish code there.
- Door dimensions: Measure width and height of the door edge to edge. A 1/8-inch difference between a 12 5/8 and 12 3/4 door decides whether the replacement fits the original overlay.
- Hinge plate pattern: Note whether the hinge plate screws into a 32mm line of holes or a proprietary three-hole pattern – this is the most common wrong-part trap we see in Sunrise Manor.
On the OEM-versus-aftermarket question, there is a real answer. For Wellborn-specific hinges and overlay plates, OEM from Wellborn is worth the wait because the overlay dimensions are tight and aftermarket plates tend to drift 1-2mm, which throws the whole door line out. For drawer glides, a quality aftermarket undermount equal to the OEM spec (Blum or comparable) is a fair, often faster choice. We source what fits your box, and we say plainly which one it is and why. You’ll also find the access we have to KraftMaid, Cambria, and Silestone runs through the same spec-grade partnerships; Mason Remodeling Sunrise Manor is an independent service provider and is not affiliated with Wellborn.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Wellborn Home Additions & ADU Is Failing
Wellborn cabinetry installed in a Sunrise Manor addition is built to last, but a few parts wear on a known schedule. These are the symptoms we’re called about most.
- Doors hang crooked or rub the frame. Usually a hinge that has lost tension or a plate pulled loose from soft particle board. The box is rarely the problem; the hinge is.
- Drawers drag or stick halfway out. A glide that has lost its glide ratio or a rail bent from overloading. Under-mount glides on a heavy drawer load fail first.
- Soft-close door hesitates or slams. The damper in the hinge has worn – common after the dry, hot stretch of a Sunrise Manor summer cycles the mechanism hundreds of times.
- Screws won’t hold – they spin in the hole. Heat-driven expansion and contraction widens the pilot hole over a few seasons. This calls for an insert or a plate change, not a bigger screw.
- A drawer box separates at the corner. The corner joint has worked loose from load, not from misuse. A new box or a re-glued and re-doweled joint fixes it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here is what a Wellborn-compatible part swap costs installed in Sunrise Manor. The full addition and ADU figures lead the range because that is where most of these jobs sit.
| Scope | Installed Price Range |
|---|---|
| Home Addition (Wellborn cabinetry) | $45,000 – $130,000 |
| ADU Construction (Wellborn cabinetry) | $90,000 – $220,000 |
| Garage Conversion | $30,000 – $80,000 |
| Cabinet Installation (part swap / box reset) | $4,000 – $13,000 |
| Single hinge, glide, or plate replacement | Quoted in writing first |
What drives the range: box size, series, finish match, and how many door faces need re-alignment. Every job gets a written price before any work starts – no verbal estimates that grow. Installation is covered by the 365-Day Done Right Promise, and if a repair fails we come back free.
DIY or Call Us?
Some checks are safe for a homeowner. Measure the door, read the series label, and confirm whether the hinge screws into a 32mm line or a three-hole pattern. Those three facts are the whole diagnosis and cost you nothing but a few minutes.
What we’d steer you away from: re-drilling hinge cups, forcing a plate into a stripped hole, or trying to true a door by bending the hinge arm. Wellborn overlay settings are small, and a wrong hole permanently changes where the door sits – that turns a part swap into a cabinet-face job. The trade-off we see every week in Sunrise Manor is a $15 part replaced by a $300 door face because someone drilled first. Call (855) 606-6122 for a written quote – estimates are free.
FAQs

How long do Wellborn hinges and glides last in Sunrise Manor? Expect 10-15 years from hinges and soft-close mechanisms and 12-18 from undermount glides under normal use. The dry heat and the cooling cycle of a Sunrise Manor home work them harder than a humid climate, so we see the first soft-close failures at the 8-year mark.
Can a failed part be repaired instead of replaced? Often yes. A loose hinge plate can be re-set with an insert, and a soft-close hinge can sometimes be re-tensioned. If the damper or glide is cracked, replacement is the honest answer. We tell you which in the written quote – call (855) 606-6122 and the visit is free.
How long does the swap take? A single hinge or glide swap is roughly 30 minutes. A full door-face re-alignment across a run of cabinets typically takes half a day. We schedule and confirm in writing before we arrive, and every crew member arrives in a marked uniform with a photo ID badge at the door.
How do you source the Wellborn part? We confirm your series and finish code from the label and match it to spec, quoting OEM or quality aftermarket by name and reason. We never claim to carry parts on a truck – the correct part is ordered to your model. Call (855) 606-6122 to start with a free estimate.
If your Sunrise Manor addition has a Wellborn part that quit, call Mason Remodeling Sunrise Manor at (855) 606-6122 for a free estimate. You’ll get a written price before any work begins, a background-checked technician introduced by name and photo before the visit, and a live person answers every call, day or night. Our technicians have up to 22 years of experience, and every install is covered by the 365-Day Done Right Promise.
Written by the team at Mason Remodeling Sunrise Manor, serving Sunrise Manor and nearby areas.












